Moldwachs (Spacewax) 450g
Item Number: 32045
| Minimum quantity: 2 | €19.90 | €44.22 / kilogram |
| €44.22 / kilogram | ||
| Minimum quantity: 5 | €19.10 | €42.44 / kilogram |
| €42.44 / kilogram | ||
| Minimum quantity: 10 | €18.50 | €41.11 / kilogram |
| €41.11 / kilogram | ||
| Minimum quantity: 20 | €17.90 | €39.78 / kilogram |
| €39.78 / kilogram |
Mold wax (Spacewax)
Universal release wax in paste form for polyester and epoxy resin processing.
Suitable for models, new tools, and continuous production.
Allows multiple demolding at temperatures up to 140°C with broken-in tools.
Application:
Use a clean, soft cotton cloth to apply the release wax. Apply the release wax generously to a visible area and polish to a high gloss with a clean cloth after approx. 30 minutes.
New molds require four to six layers of wax, whereby you must wait until the solvent components have evaporated before applying each new layer. As an additional safety measure, we recommend applying a PVA release agent for the first few demoldings.
Recommendation: Always temper new molds.
Note:
Despite rapid polishing of the applied layer, the wax film remains only on the surface of the mold without penetrating it. Due to the exothermic heat development that occurs during the first demoldings, the release wax is gradually driven deeper and deeper into the surface pores until the mold reaches a so-called “wax-rich” state. As a rule of thumb, 4-6 demoldings are required to achieve the desired state. As an additional safeguard against sticking or sticking, it is recommended to apply a PVA film during this “conditioning” of the mold, which can be easily dissolved with warm water if necessary. Once a new mold has been properly broken in this way, Spacewax 300 can be used to achieve very good results in terms of the number of possible separations.
New molds should always be tempered at 50°C for at least three hours before starting to apply the release agent.
- Contents: 450g
- High-temperature release wax up to 140°C
- Suitable as a primer for PVA release varnish
- For multiple demolding
- Easy to apply
- Good release effect, easy to polish
- For polyester and epoxy resins
5
4
3
2
1
Loading reviews...
Delete review
Information on the Authenticity of Customer Reviews
Only registered customers can submit a review, and only after purchasing the product. All visible reviews meet this requirement.
Label Elements
Hazard statements
H226 Flammable liquid and vapor. H304 May be fatal if swallowed and enters airways. H411 Toxic to aquatic life with long lasting effects. EUH066 Repeated exposure may cause skin dryness or cracking.
Precautionary statements
P210 Keep away from heat, hot surfaces, sparks, open flames, and other ignition sources. No smoking. P243 Take precautionary measures against electrostatic discharge. P273 Avoid release to the environment. P280 Wear protective gloves/protective clothing/eye protection/face protection. P301+P310 If swallowed: Immediately call a poison control center or doctor.
PHD
Daniel Dietrich
Zu den Bürgerhufen 6
04924 Bad Liebenwerda
Germany
gpsr@phd-24.de
+493534147098
